Autoquip SERIES 35 POWERED TURNTABLE - Manual (Page 13)

13
DANGER !
HIGH VOLTAGE!! Disconnect and/or lock out the electrical supply to the
power unit prior to any maintenance being performed.
5.
The base frame of the turntable has pre-drilled holes for lagging it securely to the
floor. Mark hoes, drill, and install with anchors. Turntables with oversize
platforms have minimum pull out requirements of 2,000 lbs. for each anchor.
6. Make the permanent electrical connections and operate the turntable through a
few cycles.
LIFT /TURN COMBINATIONS – Floor or Pit Installation.
1.
Make sure the lift surface is clean and level before starting.
2.
Center the turntable base on the lift. Set the turntable platform aside for now.
CAUTION!
When moving the turntable assembly, do not attempt to pick it up by the
turntable platform; it is attached and could be damaged. Pick up the
turntable from under the base frame at a joint ONLY.
3. The base plate of the turntable has pre-drilled holes for attaching the turntable
securely to the lift platform. Mark the holes, drill, and attach with Class 2 (or
higher) hardware. The turntable base may be welded to the lift platform, if
desired.
4.
Install the turntable platform to the turntable base.
5.
Position and adjust the platform in the pit making sure there is proper clearance
(1” minimum around the edges from the platform to the pit angle).
INSTALLATION INSTRUCTIONS