Autoquip SERIES 35 POWERED TURNTABLE - Manual (Page 11)

11
FLOOR INSTALLATION
1. Make
sure installation area is clean before starting.
2.
If the permanent electrical work is not complete, some means of temporary lines
with an on-off device for the power supply should be set up for testing purposes.
3.
Place the turntable in the installation area.
CAUTION!
When moving the turntable, do not attempt to pick it up by the platform; it
is attached in the center only and could be damaged. Pick up the turntable
from under the base frame ONLY using a strap sling.
4.
Make temporary electrical connections. Operate the turntable to ensure that
rotation is in the proper direction.
5. If needed, shim to the desired height. DO NOT “spot” shim. Shim the full length
of the base frame. This will prevent the plate from bending under an
exceptionally heavy load.
DANGER !
HIGH VOLTAGE!! Disconnect and/or lock out the electrical supply to the
power unit prior to any maintenance being performed.
INSTALLATION INSTRUCTIONS