Autoquip SERIES 35 POWERED TURNTABLE - Manual (Page 12)

12
6.
The base plate of the turntable has pre-drilled holes for lagging it securely to the
floor. Mark the holes, drill, and install with anchors. Turntables with oversize
platforms have minimum pull out requirements of 2,000 lbs. for each anchor.
7.
Make permanent electrical connections and operate the turntable through a few
cycles.
PIT INSTALLATION -- MODELS WITH BEVEL TOE GUARDS.
DANGER!
Do not install the turntable in a pit unless it has a bevel toe
guard or other approved toe protection. A shear point can exist
which can cause severe injury to the foot.
1.
Check the pit dimensions. Length and width should be 2" minimum longer and
wider than the turntable or lift platform, whichever is greater.
2.
Check the chase entrance into the pit. The diameter should be 3". If the
permanent electrical work is not complete, some means of temporary lines with
an on-off device for the motor should be set up for testing purposes.
3.
Lower the turntable into the pit and check for proper height. The turntable should
be solid and flush with the pit angle framing. If needed, shim to the desired
height. DO NOT “spot” shim. Shim the full length of the base frame. This will
prevent the plate from bending under an exceptionally heavy load.
CAUTION!
When moving the turntable, do not attempt to pick it up by the platform; it
is attached only in the center and could be damaged. Pick up the turntable
from under the base frame ONLY using a strap sling.
4.
Make temporary electrical connections. Operate the turntable to ensure that
rotation is in the proper direction.
INSTALLATION INSTRUCTIONS