Aquascape PRO-Fit PondSweep Skimmers (00250 & 00900) - Manual (Page 8)

8
Fig. 1 Fig. Install the latch tab with the supplied nut and bolt.
Fig.
Attaching the Liner and
Bellows Weir for the
SK1200PRO
• Make sure that there is enough slack
in the liner in the front of the skim-
mer. This will prevent the liner from
pulling away if there is any settling.
Drape the liner over the front of the
skimmer and attach it using the
spring clips. Check that the liner is
smooth across the face of the skim-
mer. (See fig. )
• Attach the liner retention frame using
the top two holes before cutting the
liner. Cut the liner even with all four
sides of the opening in the skimmer
vault, being careful not to stretch the
liner. (See fig. 5)
• Apply a bead of silicone between the
liner and the skimmer vault following
the hole pattern in the vault. Gently
press the liner to the silicone to
spread the silicone.
• Pass the bellows flange through the
opening from the inside, placing it on
top of the liner and between the liner
and the frame. This step is easier if
the latch tabs are used to hold the
bellows in place. (See fig. 6)
• Now install the remaining screws
through the retention frame, the
pre-punched bellows hole, and then
the liner. Tighten all screws to spread
the silicone and seal the liner to the
vault. Be careful not to over tighten
any screws. (See fig. 7)
Note: Power tools are not recommended
for installing the screws and may strip
the nut inserts.
• Let dry for at least one hour before
introducing water!