Aquascape PRO-Fit PondSweep Skimmers (00250 & 00900) - Manual (Page 6)

6
CAUTION: Be careful when using power screwdrivers or powered drills when installing the screws or bolts.
Over tightening can crack the liner retention frame and can strip the holes in the vault
Attaching the Liner and Bellows Weir for the SK302P, SK700PRO, SK900PRO
• Apply a bead of silicone to the face
of the skimmer. (See fig. 11)
• Place the liner against the skim-
mer and hold it in place with the
supplied clips. Make sure that
there is enough slack in the liner in
the front of the skimmer. This will
prevent the liner from pulling away
if there is any settling. (See fig. 1)
• Install the “U” frame using an awl
to help align the holes. Start at
the top of the “U” frame and using
the awl as a guide, start your first
screw. Next, install the top screw
on the other side and then repeat
with the rest of the screws.
(See fig. 1-15)
• With all of the screws started, cut
the liner using the inside of the “U”
frame as a guide. (See fig. 16)
• Tighten screws squishing out the
silicone along entire edge of “U”
frame. Apply a second bead of
silicone to inside edge of frame
and smooth out with your finger.
(See fig. 17-18)
• Insert the ratchet fasteners into
bellows from the outside of flap as
shown. (See fig. 19)
• Pull the bellows flap through the
skimmer opening and secure to the
skimmer with the fasteners.
(See fig. 0-1)
• Install the latch tab with the sup-
plied nut and bolt. (See fig. -)
Fig. 11 Apply a bead of Silicone to the face of the skimmer. Fig. 1 Place the liner against skimmer and hold in place with the supplied clips.
Fig. 1 Install the “U” frame using an awl to help align the holes. Fig. 1 Start at the “U” frame and using an awl as a guide start your first screw.