APG ACF-10 user manual - Manual (Page 13)

ACF-10 Series Rev. 1a, 2/03
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
12
Other Cautions
• If the ACF-10 is dropped or receive a strong shock, it may be damaged.
Handle with care.
• Do not use the ACF-10 in a vapor and corrosive gases or misty
environments.
• Be sure to check up the terminal numbers before wiring. Be sure to fasten
the cable gland and the cover. If the fastening is loose, this may damage the
drip-proof.
• When using the ACF-10 outside, install to avoid direct sunlight or attach a
sunshading cover to avoid the temperature rise and the effect of ultraviolet
rays.
• Check Up
Check up the ACF-10’s operational functions with the following procedures.
Be sure to wire the ACF-10 before switching on. In approximately 2 seconds,
set the OFFSET trimmer in the center to tap lightly the receiving part by a
finger nail. When the illumination of the LED moves rightward from the zero
point, the operations are regarded as normal.