Anchor CENTURY FRAME TENTS 30X30 WITH OPTIONAL WALLS - Manual (Page 7)

7
NOTE:
The center of the fabric eaves should
be approximately 3” below the frame
eaves when properly tensioned.
NOTE:
Tensioning of top can change from
installation to installation. Cable
stretch, fabric shrinkage or elongation
and other factors can require a differ-
ent amount of tension to center pole.
TENSION TOP
A firmly tensioned top is required for proper installation.
Pull fabric tightly and smoothly to minimize water pool-
ing, wind damage, fabric shifting. Use ratchets on ten-
sion straps to tension the top (See Step 6).
Now tighten all eight of the fiesta straps spaced between
the uprights (See Step 10).
13
Ratchet
Front View
Side View
TAKE DOWN
1. Remove guy webs and stakes.
2. Loosen tension straps.
3. Reverse installation steps.
14
IMPORTANT:
Check guy webs and tension straps periodically for tightness and good condition.
Re-tension as needed after windy or rainy conditions. Failure to do so may result in
pooling or failure of the tent.
Store tent in a cool, dry area. Never store while wet or damp.