Anchor CENTURY FRAME TENTS 30X30 WITH OPTIONAL WALLS - Manual (Page 6)

INSTALLING OPTIONAL WALLS
Determine proper mating of 2-piece walls with labels
on the inside. Slide tabs at top of walls into bottom
outside channel opening (see Century Frame extru-
sion drawing on Page 3).
Orient walls so that beading edges are adjacent to
uprights and the lace edges meet in the middle.
6
ATTACH WALLS TO UPRIGHTS
At each upright gather up wall and insert bottom
of beading into channel opening at top of upright.
Feed all of beading into channel.
10
11
12
FASTEN FIESTA STRAPS AND BUCKLES
(LOCATED BETWEEN UPRIGHTS)
Pull straps out so that they are not caught behind eave
bars. Insert the wire hook attached to the strap into the
upper outside channel of the eave beam as shown in the
illustrations. Make sure strap and buckle are straight and
in-line.
Run the end of the strap up through the fiesta buckle and
pull strap until wire hook stays in place.
Do not tighten at this time.
Fiesta buckle
Wire hook - hook
into upper outside
channel of eave
beam.
Eave
beam
Eave
beam
Wire
hook
Tent
top