Anchor PZ (PARTY) SERIES - PROFILE SIZE: 94MM X 48MM ADDENDUM - HEX END - Manual (Page 3)

3
After Eave purlins are installed check that uprights are vertical. Adjust
where required.
Install intermediate purlins all around in the same manner that eave purlins
were installed.
After installation of purlins and checking that all uprights are vertical, stake
remaining baseplates.
Upright Cross-cables are required on one bay for a hex end on a
rectangular frame and at every other bay on a hex tent. See Figure 5a.
Use eyebolts for connection of Cross-cables as shown on Figure 5b.
4
5
Main Arch Eave Purlin
Intermediate Purlin
Figure 4a
Figure 5a
Figure 5b
Eyebolts - use in place of
the standard bolts where
required.
Adjust cables using
turnbuckles.