Altman Lighting Chalice - Manual (Page 13)

Lighting
BRINGING IMAGINATION TO LIGHT
Lighting
BRINGING IMAGINATION TO LIGHT
M a n u a l I N S T A L L A T I O N & O P E R A T I O N
Chalice Series
57 Alexander St., Yonkers, NY 10701 Tel: 914-476-7987 Visit our website at www.altmanlighting.com
© 2012 Altman Stage Lighting, Inc.
13
MASTER MODE
( Diff erent than the Master Channel described on page 7.)
Master Mode only works while in STAND-ALONE EFFECTS MODE (see page 8). It causes the unit that is
set to Master Mode to behave like a console and Transmit 4-channel (RGBA) 8-bit DMX set on address 001,
refl ecting its present light output.
Note: Only the fi rst unit that is going to serve as the MASTER fi xture should be set to Stand-alone Eff ects
mode with Master Mode on. Stand-alone Eff ects Mode with Master Mode on should also not be used while
units are connected to a DMX console. All fi xtures following the Master fi xture should be set with the Master
Mode OFF, for Normal Operation.
To Turn on MASTER MODE:
To Turn off the MASTER MODE:
1. Place fi xture in Stand-alone Mode (see page 8)
2. Wait a few seconds until the display goes blank
3. Press and hold the [ HUNDREDS ] button
4. Press and hold the [ ONES ] button
5. Release the [ HUNDREDS ] button
6. Release the [ ONES ] button
7. Display will show
ON
for a moment to indicate new setting and then blink.
8. Address remaining fi xtures connected to the MASTER fi xture to DMX address 001
Wait a few seconds until the display goes blank
Press and hold the [ HUNDREDS ] button
Press and hold the [ ONES ] button
Release the [ HUNDREDS ] button
Release the [ ONES ] button
Display will show
OFF
for a moment to indicate new setting and then blink.