Setmode presets intensity dimcurv, Lighting – Altman Lighting Spectra Series User Manual

Page 14

Lighting

BRINGING IMAGINATION TO LIGHT

Lighting

BRINGING IMAGINATION TO LIGHT

M a n u a l

O P E R A T I O N

Spectra Series

57 Alexander St., Yonkers, NY 10701

Tel: 914-476-7987

Visit our website at www.altmanlighting.com

DMX Mode:

Set/read the DMX start address of the fi xture

Change network resolution to 8 or 16 bit

Select the interpolation mode

Show Mode:

• Selecting one of the 8 pre-programmed shows

• Change the speed of the selected show

• Turn Chase on or off

Note: When the Spectra Strip is in Show Mode, the fi xture will not respond

to any incoming DMX signal!

Select Preset

Select one of the pre-programmed presets: Concert or Theater:

CON1-CON6: Concert Mode.

• Concert mode groups individual LED Cells into groups. CON1 is

all LED cells responding to channels 1-4(RGBA). CON6 is each cell

responding to channels 1-48(RGBA).

THE1-THE6: Theater Mode

• Theater Mode groups cell by traditional border light 3 circuit / 4

circuit emulation.

Set Intensity:

• Sets the maximum intensity for the fi xture.

• Default is 255 or maximum intensity.

Dimming Curve*:

Selects the output dimming curve. Options are:

• LIN - Linear

• LOG - Logarithmic

• SQUA - Square

Default is LOG

Control Mode Selection

Preset Selection

To operate the Spectra Strip, one of two control modes must be selected: DMX Mode or Show Mode (also

known as Stand-alone mode).

Spectra Strip Presets govern the operation of the fi xture including how each cell responds, the maximum

intensity the fi xture will output and the dimming curve the fi xture will operate with.

Hold for 5 sec.

MODE SELECTION

PRESET SELECTION

Display off

DMX

SHOW

SETMODE

PRESETS

INTENSITY

DIMCURV

CON1

CON2

CON3

CON4

CON5

CON6

THE1

THE2

THE3

THE4

THE5

THE6

0 » 255

LIN

LOG

SQUA