Allworx 9202E Phones - Manual (Page 9)

Allworx Phone Model 9202E User Guide
+1 866 ALLWORX * +1 585 421 3850 Page 3
www.allworx.com
Revised: 5/21/14
2 Setup
2.1 Connect the Phone
To connect the phone:
1. Connect the cables to the jacks on the back of the phone.
Caution:
Do not connect the phone to an analog phone line. This may cause damage to the Allworx
phone, which voids the warranty.
Note:
Allworx 9202E handsets attached to the Allworx servers require using system software version
7.4 or higher. Do not attempt to install a 9202E phone on a server that is running a lower version
of software.
Cable Connections
Optional: Headset cord
Headset jack ( )
Handset cord Handset jack ( )
Ethernet cable
Network jack ( ) and Wall Ethernet jack
Power over Ethernet (PoE): provides power to the phone after connecting the
Ethernet cable.
Optional: Ethernet cable
Computer jack ( ) and the computer.
Optional: Power Supply
Phone DC jack ( ). Allworx recommends using a surge protector.
Only required if the Ethernet cable does not provide PoE
Back of Phone