Allworx 9224 Phones - Manual (Page 21)

Allworx Phone Model 9224 User Guide
+1 866 ALLWORX * +1 585 421 3850 Page 13
www.allworx.com
Revised: 5/21/14
2. Press an unused Call or Line Appearance PFK, and dial the number of the recipient of
the transfer. Talk to the recipient.
3. Press the TRANSFER button again, and then press the PFK of the original call. This
connects the two parties.
4. Hang up the handset when finished.
To cancel the transfer, press the RELEASE button. To return to the original caller, press the
PFK indicating the held call.
Allworx Server Software 7.4 or Higher
To do a one-step transfer:
On an active call, the user must have a BLF or Speed Dial PFK for the recipient of the transfer.
1. Press the BLF or Speed Dial PFK for the recipient of the transfer.
• Unattended (Blind) Transfer: skip to step 2.
• Attended (Announced) Transfer: Talk to the recipient.
2. Hang up, press the TRANSFER button, or press the XFER softkey to complete the
transfer.
To do a two-step transfer:
For use if a PFK is unavailable for the intended recipient:
1. Press the TRANSFER button.
To transfer a call to an external party while in Key System mode, press a free Line
Appearance PFK and then dial the phone number.
Note: Verify the INTERCOM button or an appearance PFK is free.
Note: The Allworx Server Administrator enables the one-step transfer
Note:
The phone configuration may not enable users to stay on the line to announce the transfer. See
“To do an Unannounced (Blind) transfer :” on page 12. for Announced transfers.