Allen&Heath XONE DB2 - Manual (Page 37)

Allen & Heath XONE:DB2 User Guide 37
AP8640_2
DIGITAL IO - X-LINK
DIGITAL INPUTS - DIGITAL OUTPUT
DIGITAL INPUTS 1&2
DIGITAL INPUT: The XONE:DB2 has two digital inputs on the rear panel designed for standard 75
Ohm RCA interface cables. These inputs are compatible with the following formats:
AES3, IEC60958, S/PDIF (Sony/Phillips Digital Interconnect Format), EIAJ CP1201, all from 32kHz to
192kHz, and up to 24bits.
DIGITAL OUTPUT: The digital output is fixed at 48kHz/24 bit, non copy protected, with a 75 Ohm
impedance.
The digital output source, and signal level is set in the Menu under “Record Setup”, see page 23 for
details.
DIGITAL OUTPUT
X-LINK
X-LINK
X-Link is a proprietary interface protocol to enable future Allen & Heath accessories and controllers to
be easily connected to the XONE:DB2. Visit www.XONE.co.uk for the latest news on X-Link enabled
products.
Dual FX Core DSP engine: 2 simultaneous FX engines with independent BPM calculation.
Analogue/Digital conversion 24 bit
Analogue/Digital Line-up +12dBu = 0dBFS
DSP processing 24 bit I/O + 48 bit EQ
DSP Mix Bus 56 bit Fixed Point
DSP core sampling frequency 48kHz
USB soundcard sampling frequency 48kHz
SPDIF input sampling frequency range 32kHz to 192kHz
SPDIF Output sampling frequency 48kHz
DIGITAL ARCHITECTURE SPECIFICATION