Allen&Heath ICE-16D - Manual (Page 16)

Allen & Heath 16 ICE-16D User Guide
RECORDING DIRECT TO USB MEMORY
DEL PREV NEXT PLAY/STOP REC
Record
TIME
DEL PREV NEXT PLAY/STOP REC
Record
TIME
QUICKSTART
1.
Plug in your USB hard drive or USB
memory stick (see www.allen-heath.com
for verified memory devices).
Power ON
Format the memory device by pressing
DEL+REC for 1 second. The display will show
“For” and the dots will flash. The memory will
be tested (display “tst) and the ICE-16 will au-
tomatically be set to either 24 bit (“Hi”) or
16 bit (“Lo”) mode depending on the memory
quality.
Press & hold DEL & REC for 1 second
Confirm with PLAY/STOP
Check the sample rate the recorder is set to by
pressing & holding TIME. The set sample rate
will be displayed. For 16 channel recording this
must be either 44.1 or 48kHz. Select the sample
rate by continuing to hold TIME and pressing
either PREV or NEXT. If you choose 88.2 or
96kHz then only channels 1-8 will be recorded.
Select sample rate (while holding TIME)
DEL PREV NEXT PLAY/STOP REC
Record
TIME
Press REC to start the first recording. The dis-
play will rotate segments and show the Song (or
recording) number and the Record LED will be
lit red. Press START/STOP to stop the record-
ing then REC to stop and start the next one.
Remaining time in minutes is displayed every 10
seconds (maximum 99 is displayed).
Press REC to start recording.
Press START/STOP to stop recording.
2.
3.
4.
99 1 10 2 11 3 12 4 13 5 14 6 15 7 16 8
DEL PREV NEXT PLAY/STOP REC
Record
TIME
USB DRIVE
Hi Level
Signal
MONITOR SEL IN/OUT MONITOR
PHONES/MONITOR
MONITOR LEVEL
MIN MAX
OUT
ALLEN&HEATH