AirLive WN-360USB - Manual (Page 49)

WN-360USB User’s Manual 44
2.7.1 WPS Setup - PBC (Push-Button Configuration)
1. Right-click the AirLive configuration utility icon located at lower-right corner of computer desktop
and then click ‘Launch Config Utility’.
2. Click ‘WPS’ menu, and the following settings will appear.
3. Set ‘Config Mode’ to ‘Enrollee’, and then push the ‘WPS’ button on your wireless access point
(the button used to activate WPS standby mode may have another name), or use other way to
start WPS PBC standby mode as the instruction given by your wireless access point’s user
manual.
You can also set ‘Config Mode’ to ‘Registrar’. In this mode, this wireless network card will wait for
other WPS-enabled access points to send WPS pairing requests. Please refer to the instruction
given by your wireless access point’s user manual to understand how to send WPS requests.
4. Before you start to establish the wireless connection by using WPS, you can click ‘Rescan’ button
to search for WPS-enabled access points near you again, to make sure the WPS function of your
access point is activated.