AirLive WL-2000CAM - Manual (Page 39)

AirLive WL-2000CAM User’s Manual
36
Start time, End time
Specify the Start time and the End time.
Use the same time schedule every day
When this is checked, the Start time and End time set to Mon (Monday) are applied to all days. In this case,
the Start time and End time of the other days than Mon (Monday) cannot be input.
6-2-5 Motion Detection
When you click Motion Detection on the Advance mode menu, the Motion Detection setting menu appears.
There are three Motion Detection functions as sensors to set for different detecting zones. Each one has
Threshold and Sensitivity inputs which you can adjust to specific zone sequentially. Motion Detection function
can support to FTP, SMTP and Alarm output for capturing and sending images or starting alarm output.
Click it On when you use the Motion Detection function and detecting zone appears for adjusting and moving.
The common setting options are displayed below. If you do not wish to use the Motion Detection function,
click it Off and press OK.
Motion Detection 1：Click it on for using Motion Detection 1 function as a sensor. You can adjust and move
the detecting zone by using mouse.
Motion Detection 2：Click it on for using Motion Detection 2 function as a sensor. You can adjust and move
the detecting zone by using mouse.
Motion Detection 3：Click it on for using Motion Detection 3 function as a sensor. You can adjust and move
the detecting zone by using mouse.
Threshold：You can use the tool bar to set up-limit value. When detecting zone signals are over
setting value, it would carry on assigned work.
Sensitivity：You can use the tool bar to set down-limit value. When detecting zone signals are over
setting value, it would carry on assigned work.