AirLive WL-2000CAM User Manual

Page 16

AirLive WL-2000CAM User’s Manual

browser to save the setting data file to your specified location.

Restore setting：Load the saved setting data of the device. Click Browse and select the file in which the setting

data is stored. Click OK, and the device is adjusted according to the loaded data and restarted.

Firmware update：Upgrade the device software. Click Browse and select the file for upgrading. A confirmation

dialogue will appear. Click OK to start upgrading. The device will reboot upon completion.

Note:

• Use only upgraded files that are special for this device. Problems may occur otherwise.

• Do not turn off the device power or disconnect the network until the upgrading is completed.

Upload language pack：Upgrade the device language pack. Click Browse and select the file for upgrading. A

confirmation dialogue will appear. Click OK to start upgrading. The upgrade is applied immediately. The default

language is “English.”

6-1-2 Camera

6-1-2-1General

RTSP: Switch the RTSP streaming On/Off.

Note：

• RTSP: Real Time Streaming Protocol. RTSP is supported by most of the media clients. (RealPlayer,

Media Player, QuickTime, etc…)

Image Rotate：Enables user to mirror or flip the display screen.

Night Mode：Turn Night Mode ON/OFF.

Lighting：Choose the lighting environment among 50Hz, 60Hz and Outdoor.

White Balance：Choose the White Balance to Auto, Fluorescent, Incandescent and Black&White.

IR: Turn LEDs ON/OFF, or Select auto mode. In auto mode, provide threshold adjustment for LEDs auto-ON

and auto-OFF respectively.