AirLive VoIP-400 Series - Manual (Page 29)

ITG User’s Guide
1.Gate Keeper Mode: The default setting is off. This field is to select the co-operation mode with
some gatekeeper(s). Three options available:
- off: disables gatekeeper co-operation,
- auto: enables auto-discovery of the gatekeeper,
- manual: enables gatekeeper co-operation in manual operation (the gatekeeper address must
be properly assigned).
The following fields must be filled up when the Gate Keeper Mode is set to either auto or manual.
2.Gate Keeper Address: Specify the gatekeeper address when configured to manual mode. When
auto mode is desired, this field should be set to auto.
3.Allow Calls Without Gate Keeper: This field is to inform the H.323 stack to allow calls when
the endpoint is not registered with a gatekeeper.
4.Registration Type: This field is to set the endpoint registration type. This specifies how the
endpoint will register itself with the gatekeeper.
5.Max Registration Retries: This field is to control how many registration attempts will be made
before the endpoint considers itself to have failed registration.
6.Time To Live:
7.Endpoint Prefix: This command is used to set the H.323 prefix that the ITG uses when
registering to an H.323 gatekeeper.
8.Terminal ID: To specify GW’s ID.
9.GateKeeper ID: To specify Gate Keeper’s ID.
You'll have to reboot the system to make your changes active!
Please select Main Menu\Configure System Settings\H.323 Parameter Settings\H.323
Aliases Settings
Alias: This field is to create or delete aliases that are registered with the gatekeeper.
Configuring ITG from a Web Browser 29