AirLive IAS-2000 v2 - Manual (Page 37)

IAS-2000 v2
User’s Manual
. 30
5.1.3 WAN1 Configuration
There are 3 methods that WAN1 Port supports: Static IP Address, Dynamic IP Address, and PPPoE Client.
y
Static IP Address: Manually specifying the IP address of the WAN1 Port which is applicable for the network
environment where the DHCP service is unavailable. The option of 802.3ad for WAN2 is only available when
WAN1 is using a static IP address. The fields with red asterisks are required. Please fill in these fields.
¾ IP Address: The IP address of the WAN1 port.
¾ Subnet Mask: The subnet mask of the WAN1 port.
¾ Default Gateway: The gateway of the WAN1 port.
¾ Preferred DNS Server: The primary DNS Server of the WAN1 port.
¾ Alternate DNS Server: The substitute DNS Server of the WAN1 port. This is not required.
¾ Enable Bridge Mode: WAN1 is set to use a static IP address and “Enable Bridge Mode” is checked,
WAN2 and all LAN ports will share the WAN1 IP address and go into bridge mode as well. See the following
figures. The PC connected to LAN1 or LAN 2 must be set to static IP address manually, or it can receive the
IP address from upper DHCP server via WAN1. The IP address they received is the same IP subnet with
WAN1 IP.