AirLive GW-300R - Manual (Page 89)

FAQ and Troubleshooting
AirLive GW-300R User’s Manual 85
yes, please execute Browser, like Mozilla and key 192.168.1.254 in address.
If not, please ip
If
config /release, then ipconfig /renew.
Whatever I setup, the pc can not get ip. Please check Status Led and refer to the Q2:
2.Why can I not connect the router even if the cable is plugged in Lan port and the led is
light?
irst, please check Status Led. If the device is normal, the led will blink per second.
If not, please check How blinking Status led shows.
Status Led is bright or dark in work: The system hanged up .Suggest powering off and on
the router. But this symptom often occurs, please reset to default or upgrade latest fw to
try again.
Status led flashes irregularly: Maybe the root cause is Flash rom and please press reset
Button to reset to default or try to use Recovery mode.(Refer to Q3 and Q4)
Status flashes very fast while powering on: Maybe the router is the recovery mode and
please refer to Q4.
3.How to reset to factory default?
A: F
There are many abnormal symptoms as below:
ress Wireless on /off and WPS button simultaneously about 5 sec
Status will start flashing about 5 times, remove the finger. The RESTORE process is
completed.
A: P