AiM Yamaha R6 - Manual (Page 14)

MXL Plug&Play kit for Yamaha R1 2004/2005/2006 – R6 2004/2005/
User manual
Release 1.01
13
www.aim-sportline.com
1 2
4.2 – Setting mode
“Setting mode” allows to modify some ECU map settings. They changes depending on if
it’s a stock ECU or an YEK kit.
Powering on MXL it starts in “Running Mode”: press “MENU/<<” and “VIEW/QUIT” at a
time to enter setting mode. The display shows “DIAG SETUP” message as here below.
Confirm pressing “OK/MEM”.
The display shows settable parameters in different pages. Use “>>”/”<<” buttons to scroll
the pages. Once reached the page to be set press “MEM/OK” to enter that page setting,
use “>>”/”<<” buttons to modify the settings and press again “MEM/OK” to save the new
settings ad exit. In case no modification has been made but the page has been entered it
is anyway necessary to press again “MEM/OK” to exit the page.
1 3
4.2.1 – Setting mode with stock ECU
In case the bike has a stock ECU it is only possible to change each cylinder injection
times (and consequently CO value). This setting can be made with the engine on or off.
The below table shows settable parameters.
PAGE DESCRIPTION VALUE
CO CYLINDER 1 Modifies first cylinder CO value (the
higher is the value the richer is the
mixture).
Allowed values are between
-128 and +127. Default
value is 0.
CO CYLINDER 2 Modifies second cylinder CO value (the
higher is the value the richer is the
mixture).
CO CYLINDER 3 Modifies third cylinder CO value (the
higher is the value the richer is the
mixture).
CO CYLINDER 4 Modifies fourth cylinder CO value (the
higher is the value the richer is the
mixture).
Refer to Yamaha technical manual for further information.
To exit setup mode recycle power on the bike.