AiM Yamaha R6 - Manual (Page 11)

MXL Plug&Play kit for Yamaha R1 2004/2005/2006 – R6 2004/2005/
User manual
Release 1.01
10
www.aim-sportline.com
4
Chapter 4 – First start up and working mode
MXL Plug&Play kit for Yamaha R1/R6 can be installed on stock bikes and on bikes
equipped with original YEC (Yamaha Engineering Corporation) kit. Once the bike powered
on, MXL automatically recognizes and shows on the display the kind of ECU installed.
Supported ECUs are:
• Standard ECU (stock): the display shows “ECU MODEL STD” (image below on the
left);
• YEC kit (YEC ECU): the display shows “ECU MODEL KIT” (image below on the
right).
9
4.1 – Running mode
After ECU recognition, MXL starts working in “Running mode” and shows and manages,
as default settings, different information according on MXL model.
MXL STRADA
RPM 1 from ECU Shown
Rear speed wheel from ECU Shown
Water temperature from ECU Shown + alarm LED
Air temperature from ECU Shown + alarm LED
Oil pressure from sensors alarm LED
Fuel level alarm from sensors alarm LED
Turning lights from sensors alarm LED
High beam from sensors alarm LED
Engaged gear (neutral included) automatically calculated Shown
Yamaha error code from ECU Available 2
1 RPM data can be sampled both by the bike ECU and by a stock sensor. To use the data coming from the
ECU set “RPM” box in MXL system configuration layer on “ECU”; to use the data coming from the stock
sensor set “RPM” box in MXL system configuration layer on “AIM sensor”. Refer to Race Studio
Configuration
user manual for further information concerning MXL configuration. In case a deep analysis of
RPM channel is wished use data coming from the stock sensor (set “AIM sensor”) whose sampling
frequency is higher.
2 Yamaha_ERR channel is not shown by the default configuration. To see it on MXL display configure the
logger using Race Studio Configuration software. Refer to Race Studio Configuration user manual for
further information concerning MXL channels configuration.