AiM Yamaha R6 - Manual (Page 12)

MXL Plug&Play kit for Yamaha R1 2004/2005/2006 – R6 2004/2005/
User manual
Release 1.01
11
www.aim-sportline.com
MXL PISTA
RPM 3 from ECU Shown and recorded
Rear wheel speed from ECU Shown and recorded
Water temperature from ECU Shown and recorded+alarm LED
Air temperature from ECU Shown and recorded+alarm LED
Oil pressure from sensors alarm LED
Fuel level alarm from sensors alarm LED
Turning lights from sensors alarm LED
High beam from sensors alarm LED
Engaged gear (neutral included) internally calculated Shown and recorded
Yamaha error codes from ECU Available 4
3 RPM data can be sampled both by the bike ECU and by a stock sensor. To use the data coming from the
ECU set “RPM” box in MXL system configuration layer on “ECU”; to use the data coming from the stock
sensor set “RPM” box in MXL system configuration layer on “AIM sensor”. Refer to Race Studio
Configuration
user manual for further information concerning MXL configuration. In case a deep analysis of
RPM channel is wished use data coming from the stock sensor (set “AIM sensor”) whose sampling
frequency is higher.
4 Yamaha_ERR channel is not shown by the default configuration. To see it on MXL display configure the
logger using Race Studio Configuration software. Refer to Race Studio Configuration user manual for
further information concerning MXL channels configuration.