ADS-TEC RAC2000 User Manual - Manual (Page 11)

RAC2000 series 10
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
3 Mounting
3.1 Mounting options
This device is designed for industrial use and can be used in all places, where the required ambient conditions are
not disregarded. For reason of an easier installation and better operation, this device should be installed in a
place where there is no interference with the radio characteristics, if possible. Radio characteristics are primarily
affected by iron beams and massive concrete walls.
Warning:
Avoid overheating in operation. Never expose the device to any direct irradiation
by the sunlight or any other light source. IP 65 protection is only achieved with
proper installation. The tolerance in drawings amounts to +/‐ 1.5 mm.