A2Z Ozone Bed Sterilizer - Manual (Page 8)

8
 After switched “ON”, it shows TIME and SIGN of each stage by turns. The
procedure and sign of each stage is as following:
Vacuum (CC)  Ozone generating (O3)  Ozone-maintain (OF)Ozone
decomposition (O2)  OVER (OP).
 The procedure could be stopped when vacuum by switch “OFF”, otherwise, in
other stages, any press on thin film will be no function.
 It shows “OP” when whole procedure is completed and buzz 3 times at the same
time. After that turn off the main switch.
Attention:
 The device automatically complete the sterilization cycle or can be
stopped by man force. If you need to continue the sterilization process,
you have to turn off the main switch and switch on again; otherwise,
there will be no function on the electronic panel.
 If the device enters into the ozone generating stage, all keys on thin
film panel remain without function. If want to stop the procedure by
force, you have to turn off the main switch.
Auto Operation:
Mode 1 is suitable for hospital uses, while Mode 2 is suitable for hotel uses.
● After main switch is turned on the default operation is manual and the
light of channel 1 is on which shows
“18” on the display.
● Press “Mode Auto Select 3 Channels” to switch into auto procedure.
Then you could switch on Mode 1 or Mode 2, and the relevant light will
turn on and all channels are also switched on. The device will start to