2N VoiceBlue MAX v1.0 User Manual
Page 54
54
CallBack function is enabled.
GSM number (CLIP) – user identification in a GSM/UMTS network.
AutoDial – enable/disable CLIP routing for the selected CLIP.
Dial to VoIP – enter the VoIP destination number for CLIP routing.
Auto CallBack – enable/disable CallBack for the selected CLIP.
Limit – set the maximum call length (in minutes).
Note
Remember to activate the CallBack mode in the GSM incoming
window for a proper CallBack function.
groups
Mobility Extension
The table registers the Mobility Extension users.
Name – enter the user name for calling to VoIP.
User – enter the registration user name for VoIP.
Password – enter the registration user password for VoIP.
GSM number (CLIP) – enter the user SIM card CLIP.
Follow me function – enable/disable call forwarding to a mobile user station
(based on CLIP).
SMS at no answer function – enable/disable sending of information SMS on
missed calls.
Note
You are recommended to read the Mobility Extension section on
page carefully before using the Mobility Extension function.
Ethernet configuration
This window helps you configure the Ethernet interface of your gateway.
Use DHCP – enable/disable the DHCP client function in
.
2N VoiceBlue
®
MAX
IP address – the fixed IP address (v4) of the
Ethernet
2N VoiceBlue
®
MAX
interface.
Subnet mask – the subnet mask for the
Ethernet interface.
2N VoiceBlue
®
MAX
Default gateway – The IP gateway IP address (v4) in the Ethernet network.
Caution
Incorrect settings, e.g. enabling the
service, may
DHCP client
result in a denial of access to the
configur
2N VoiceBlue
®
MAX
ation. To avoid this, restore the GSM gateway default settings.
Refer to