2N Helios IP Uni - Manual (Page 22)

22
2N TELEKOMUNIKACE a.s., www.2n.cz
®
IP Address Retrieval
Take the following steps to retrieve the IP address: 2N
®
Helios IP Uni
Connect (or, if connected, disconnect and reconnect) to the 2N
®
Helios IP Uni
power supply.
Wait for the second sound signal .
Press the quick dial button 5 times.
2N
®
Helios IP Uni will read its IP address.
If the address is 0.0.0.0, it means that the intercom has not obtained the IP
address from the DHCP server.
Static/Dynamic Address Setting Mode Switching
In case your device is equipped with 1 or 2 buttons, you can 2N
®
Helios IP Uni
switch the modes using one button only.
Connect to the power supply (or, disconnect and reconnect it 2N
®
Helios IP Uni
if already connected).
Wait for the first acoustic signal .
Press button 15 times. the quick dial
The acoustic signal indicates mode switching.
Wait until the device is restarted automatically.
Note
Be sure to press the button sequence within thirty seconds after the
sound signal for security reasons. Up to 2 s intervals are allowed between
the presses.