2N 4G wireless router 2N SpeedRoute - Quick start, 1896 v1.01 User Manual
2N Accessories communication

1. In the address window, write the IP
address: 192.168.1.1 to get into the
basic login dialogue.
2. Log in as Administrator. Fill in the fields
as follows.
User: Admin Password: 2n
· LTE/UMTS/GSM setup
1. Use the Wizard menu to set a quick
Internet
connection
(short
form
setting). Be sure to confirm any change
in the Wizard submenus using the
Apply button in the right-hand bottom
corner.
2. If you use a PIN protected SIM card,
set the PIN in the WIZARD->SIM
menu. Then enable the Remember
item to make the gateway use this PIN
after restart.
3. Use the WIZARD->Internet menu to
set
the
Internet
connection
parameters. These parameters are set
automatically
for
most
Internet
providers. Check the APN [list] for
your provider. If your provider is not
included, fill in the APN and Dial items
using information obtained from your
Internet provider. For some providers,
it is necessary to fill in the User and
Password fields too.
4. Use the WIZARD->Wireless menu to
enable the WiFi connection in your local
network (Enable). Use encoding to
protect your LAN against unauthorised
access if necessary. You are suggested
to use the WPA or a higher encoding
system to get the proper level of
protection.
5. Check the current state of the router in
the STATUS menu where the most
important information is displayed. The
Status field displays the Internet
status: Connected. Now you can start
browsing through the Internet.
6. In this menu you can check such
gateway parameters as the connection
type, provider, signal strength and
some more parameters important for
the gateway function.
7. For more advanced settings and rules
such as SIP connection, Firewall and
many others refer to the CD manual.
8. Use the LOG OUT button in the left
bottom
corner
to
leave
the
configuration interface. Logout is done
automatically after 20 minutes of
inactivity.
Product versions:
· 1. LTE Euro
(501830x)
· 2. LTE US
(501833x)
· 3. LTE II
(501850x)
· 4. HSPA+ version
(501820x)
· 5. HSPA version
(501840x)
See more information in users guide on CD
EC Declaration of Conformity
Hereby, 2N TELEKOMUNIKACE a.s., declares that the 2N
®
SpeedRoute product is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC. Refer to the CD-ROM or our
websit
© 2013, 2N TELEKOMUNIKACE a.s. – Prague, LH 1896, v.1.01