Echo WT24 Owners Manual - Manual (Page 9)

WHEELED TRIMMER
5
ENGLISH
Section
SELF-PROPELLED BAIL (WT24S ONLY)
Engages the self propel mode. Pull up the self-propelled
bail located under the handlebar to start the self-propel
mode.
7
1
2
3
4
5
FEATURES & CONTROLS
3
The following descriptions define some of the features and
controls of your machine.
REFER TO ENGINE OWNERS MANUAL FOR COMPLETE
ENGINE OPERATING INSTRUCTIONS.
` TRIMMER BAIL
When the trimmer bail is engaged, the trimmer disk is
rotating. Release the trimmer bail to stop the Trimmer.
Wait until the trimmer disk has stopped rotating and the
engine is shut off to inspect or service the Trimmer.
1
MOW BALL
Cast iron design provides superior durability and ease of
cutting height change.
5
TRIMMER HEAD DISK
Patent pending design allows for quick trimmer line
replacement when needed.
4
THROTTLE CONTROL LEVER
Move throttle to the START position for starting. Operate
engine with the throttle in the (F) FAST position. Move
throttle to the (S) SLOW to idle engine down and then into
the STOP position to shut engine off.
2
1
6
2
4
5
OFF-SET TRIMMING KNOB (WT24 ONLY)
Loosening the T-shaped knob will allow the cutting head
to pivot left or right up to 10 degrees of angle. (Slightly
lifting the rear wheels off the ground will assist in pivoting
the machine to the desired degree of angle for use). Re-
tighten knob when desired degree of pivot is attained.
3
TILT CONTROL KNOB (WT24T ONLY)
Pull out tilt control knob and tilt machine to the left to
adjust the degree of tilt for the trimmer head and body
when using the Off Center Tilt (OCT) feature. Release
knob when desired angle is reached.
6
4
5
1
2
7
8 WT24S
WT24T
WT24
8
SHIFT LEVER (WT24S ONLY)
Used to adjust the trimmer speed. Position 1 is the slowest
and position 3 is the fastest. The ground speed ranges
from 1-3 mph.