Warning, English – Echo WT24 Owners Manual User Manual
Page 17
WHEELED TRIMMER
13
ENGLISH
SERVICE & MAINTENANCE
BEFORE INSPECTING OR SERVICING ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE,
DISCONNECT SPARK PLUG WIRE FROM SPARK PLUG AND MAKE SURE ALL MOVING PARTS HAVE COME TO A COMPLETE STOP.
WARNING
9. Reinstall mow ball (1), disk head (2), spacers (3),
and spindle spacer (4). Ensure spindle spacer is ori-
ented as shown in Figure 5.13.
Figure 5.11
Figure 5.13
Figure 5.14, Remove undercarriage cover
Figure 5.12
8. With belt installed onto trimmer, mount trimmer base
plate (8) onto trimmer body (7) and fasten with the
six bolts (5), washers and nuts at the front of the
trimmer and torque to 13 ft-lbs. Then fasten the six
bolts (6) on the side of the trimmer and torque to 15
ft-lbs.
5.7 WT24S CUTTING HEAD DRIVE BELT
REPLACEMENT
To replace cutting head drive belt on WT24S:
1. Remove the two 5/16 x 1" screws (5) securing the
undercarriage cover (6) and set cover aside.
To prevent fluid spills, it is recommended that the
engine oil and gasoline be removed before beginning
the belt removal/service procedures.
WARNING