beautypg.com

English – Echo WT24 Owners Manual User Manual

Page 13

background image

WHEELED TRIMMER

9

ENGLISH

SERVICE & MAINTENANCE

BEFORE INSPECTING OR SERVICING ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE,

DISCONNECT SPARK PLUG WIRE FROM SPARK PLUG AND MAKE SURE ALL MOVING PARTS HAVE COME TO A COMPLETE STOP.

WARNING

5.3 CUTTING STRING REPLACEMENT

To replace the cutting string:
1. Fold a 20" piece of cutting string in half.

Insert the piece into slot of trimmer head

disk until the bend in the string is past the

line holder tab.

2. Pull the string underneath the tab until

secured in place. It may be necessary to

remove pieces of broken or worn string before

new string can be properly installed.

Wheeled trimmers come standard with ECHO Cross Fire

®

cutting string in .175" diameter. Replacement cutting string is

available in .175" or .155" diameters in ECHO Cross Fire

®

or .155" in the round design. See Section 8 - Options, for a

complete list of replacement cutting string options.

WARNING: Cut replacement string pieces to no longer than 20" (50

cm). Pieces longer than 20" (50 cm) can and will damage the trimmer shield.

The standard cutting height is 2-3/4". The cutting height

can be adjusted up in 1" increments. To adjust the cutting

height:
1. Insert a 1-1/16" open end wrench or wrench from

77524-00 wrench kit through opening on the trimmer

disk head and onto mow ball.

2. NOTE: It is important to orientate the wrench with

narrow side to the right as shown in Figure 5.1. This

will prevent having to back the wrench off to remove it

from the disk head slot.

5.4 CUTTING HEIGHT ADJUSTMENT

Figure 5.1, 1-1/16" open-end wrench for Trimmer ball

Figure 5.2, 1" open-end wrench on spindle spacer

3. Place 1" open end wrench or wrench from 77524-00

wrench kit on spindle.

Note: A wrench kit is available for removing mow ball,

please order kit #77524-00 from your local dealer.