Echo WT24 Owners Manual - Manual (Page 15)

WHEELED TRIMMER
11
ENGLISH
SERVICE & MAINTENANCE
BEFORE INSPECTING OR SERVICING ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE,
DISCONNECT SPARK PLUG WIRE FROM SPARK PLUG AND MAKE SURE ALL MOVING PARTS HAVE COME TO A COMPLETE STOP.
WARNING
5.6 WT24 AND WT24T CUTTING HEAD
DRIVE BELT REPLACEMENT
To replace drive belt on WT24 and WT24T:
3. Remove the six bolts (5), washers and nuts at the
front of the trimmer and three bolts (6) from each
side of the trimmer.
1. Tip machine back onto handle bar and support main
body 4-1/2" off of the ground. See Figure 5.6.
2. Remove mow ball (1), disk head (2), spacers (3), and
spindle spacer (4). See Section 5.3 cutting head ad-
justment for mow ball removal.
Note: To release spin-
dle spacer, gently tap
on spacer to remove
from spindle shaft.
Figure 5.6
Figure 5.7
To prevent fluid spills, it is recommended that the
engine oil and gasoline be removed before beginning
the belt removal/service procedures.
WARNING
Decreasing belt tension setting