English – Echo WT24 Owners Manual User Manual
Page 11
WHEELED TRIMMER
7
ENGLISH
OPERATION
The Tilt & Trim feature is used to trim in hard to reach
places. This feature enables both the trimmer head and
body to tilt for trimming close to the ground.
To engage the Tilt & Trim feature, pull adjustment knob
and lift on the handlebar to set the machine in one of the
three additional settings that are available. Release knob
when desired angle is set. Levels available are:
The WT24S can be used in either push or self-propelled
mode.
TO OPERATE THE SELF-PROPELLED FEATURE:
1. Pull the bail spring handle back.
2. Push forward on the Drive Control lever (on left of
handlebar) until it "clicks" into place.
3. Adjust the speed with the gear shift lever. Position 1
is the slowest and 3 the quickest. The ground speed
ranges from 1-3 mph depending on terrain and material
trimming conditions.
TO OPERATE THE SELF-PROPELLED TRIMMER
CONTROL:
1. With the bail spring pulled back, push forward on the
Trim Control lever (on right of handlebar) until it "clicks"
into place.
2. To stop the self-propelled or trimmer control features,
release the bail spring handle and it will automatically
push back on both control handles, disengaging them
automatically.
The Wheeled Trimmer can be adjusted to mow at an
angle. The trimmer body pivots to the left or right up to 10
degrees. To adjust the off-set trimming setting:
1. Loosen the T-shaped knob located on the base of the
machine at the rear.
2. Pivot the machine in the desired direction and desired
angle for use.
3. Re-tighten the knob.
4.4 WT24 — OFF-SET TRIMMING
4.5 WT24T — TILT & TRIM FEATURE
4.6 WT24S — SELF-PROPELLED OPERA-
TION
Off-set trimming adjustment knob location
5 degrees
14 degrees
10 degrees