beautypg.com

Operation, 1 fill the fuel tank, 2 starting machine – Echo LS21 Owners Manual v.2 User Manual

Page 12: 3 stopping machine, Operation 4, Warning

background image

8

LOG SPLITTER

Section

oPeraTIon

4

4.2 sTarTInG maCHIne

4.3 sToPPInG maCHIne

warnInG

Move the machine to a clear, level area outdoors before

starting. Do not operate in the vicinity of bystanders.
1. Check engine oil and hydraulic oil levels before

starting.

2. Turn the fuel cut-off switch to the ON position, if

applicable.

3. Turn the engine switch to the ON position, if

applicable.

4. Place the throttle control midway between the SlOW

and FAST positions. If starting a cold engine, move the

choke control into the CHOKE position.

5. Pull the recoil starter until light resistance is felt. Then,

pull briskly. Repeat until the engine starts. Make sure

the starting cord retracts after each pull.

6. As the engine warms, gradually turn the choke off.
7. Move the throttle to the FAST position.

1. Move throttle lever to the SlOW position.
2. Turn the engine stop switch (if equipped) to “OFF” (“O”

position) to stop the engine.

or
3. Move the throttle past the SlOW position to shut off

engine.

4. Close the fuel valve.

4.1 FIll THe Fuel TanK

warnInG

gasoline and diesel fuels are highly

flammable and their vapors are

explosive. To prevent personal injury

or property damage:
Store fuel only in approved containers,

in

well

ventilated,

unoccupied

buildings, away from sparks or flames.

A container with a capacity of 2 gallons or less with

a pouring spout is recommended. Do not fill the fuel

tank while the engine is hot or running, since spilled

fuel could ignite if it comes in contact with hot parts

or sparks from ignition. Do not start the engine near

spilled fuel. Never use fuel as a cleaning agent. DO

NOT MIX OIl WITH FuEl.

noTe

Move machine to a clear, level area outdoors before

starting. Do not operate in the vicinity of bystanders.

As with any other piece of outdoor equipment, getting the

feel for how your machine operates and getting to know

the best techniques for particular jobs are important to

overall good performance.

use only those types of fuels that are recommended in

your Engine Owner’s Manual.

To add fuel:
1. Stop engine, wait for all parts to stop moving and

disconnect spark plug wire. Allow the engine and muffler

to cool for at least three minutes.

2. Clean area around fuel fill cap and remove cap.
3. using a clean funnel, fill fuel tank to 1/2” below bottom

of filler neck to provide space for any fuel expansion.

Install fuel fill cap securely and wipe up any spilled

gasoline.

FOR THE SPECIFIC STARTINg, OPERATINg AND

SERVICE INFORMATION PERTAININg TO yOuR

EXACT ENgINE MODEl, AlWAyS CONSulT THE

ENgINE OWNER'S MANuAl FIRST.

This manual is related to the following products: