Echo DL10570 Owners Manual v.1 - Manual (Page 13)

Debris Loader Owner’s Manual 9
ASSEMBLY
2.5 DISCHARGE SUPPORT (725cc MODELS)
2.4 ATTACH BLOWER DISCHARGE
1. Connect one end of the discharge support tube to the
clevis at the end of the discharge tube. Use a 5/16" x
2" bolt, two washers and one nylock nut.
2. Connect the other end of the discharge support tube
to the trailer frame clevis located between the engine
and battery. Use a 5/16" x 2" bolt, two washers and
one nylock nut.
1. Slide the flex hose and clamp ring over the end of the
discharge tube.
2. Evenly tighten the four 3/8" bolts in the ring clamp to
fasten the hose to the discharge tube.
2.6 DISCHARGE TRANSITION (725cc MODELS)
2.4.1 670cc MODELS
1. Slide the blower tube discharge clamp underneath the
mounting flange on the debris loader frame.
2. Install the second half of the shim, spacer and clamp
(included in owner's kit) to the tube and flange with 3/8"
x 1-1/4" bolts and nylock nuts (Figure 6). Rotate the
tube 360 degrees to make sure it is mounted correctly.
Lock it in place with the lock lever.
BOLT
3/8” x 1-1/4”
NUT
3/8” NYLOCK
CLAMP
DISCHARGE
SPACER
SHIM
TUBE
DISCHARGE
BLOWER
Figure 6, Blower discharge, DL12670 (75124)
2.4.2 ALL OTHER MODELS
1. Point the discharge tube weldment in the desired direc-
tion. Then, place the tube on the debris loader frame
mounting flange.
2. Attach the discharge tube weldment to the mounting
flange with six 3/8" x 1-1/4" bolts, twelve flat washers
and six nylock nuts.
The machine may or may not have been shipped with
a battery depending on your area. If you did not receive
a battery with your machine, you will need to purchase
one.
Use a battery that meets or exceeds the following
specifications:
Nominal Voltage: 12V
CCA @ 0 Degrees: 240
CA @ 32 Degrees: 335
Size: 7-3/32" x 7-11/16" x 5-1/8"
Rated Capacity: 33.0 AH
Terminal Type: M6 bolt and nut
To connect the battery:
1. Open the battery box and insert a 12V battery of proper
specifications (see above) into the battery box.
2. Attach the positive (red) battery cable from the engine
to the positive battery terminal.
3. Attach the negative (black) battery cable from the
engine to the negative battery terminal.
4. Secure the cover on the battery box with the tarp
strap.
2.7 CONNECT THE BATTERY (12" MODELS)