beautypg.com

Warning, 3 removing the blades 5.4 sharpening the blades – Echo 74500 Owners Manual v.4 User Manual

Page 18

background image

5" and 8" Skid Steer Chipper Owner's Manual

16

SERVICE & MAINTENANCE

BeFOre iNSPeCtiNg Or ServiCiNg aNy Part OF tHiS MaCHiNe, SHut OFF POWer SOurCe,

diSeNgage tHe HydrauliCS aNd Make Sure all MOviNg PartS Have COMe tO a COMPlete StOP.

Warning

disconnect the hydraulic hoses from the skid steer.
Position the discharge chute to the side of the chipper.
remove the two bolts on the chipper housing.
tip the chute and housing away from the chipper to

expose the rotor and the blades.
use a pry bar between two of the fan blades to prevent

the chipper from rotating during blade removal and

installation.
remove the blades making sure not to slip the wrench,

the chipper blades are sharp.
the chipper blades are reversible. if the blades have

not been reversed, flip the blades 180 degrees and

reinstall.
if the chipper blades need to be sharpened refer to

Section 5.4 of the manual.
inspect all components of the chipper for damage and

replace if necessary.

1.
2.
3.
4.

5.

6.

7.

8.

9.

Never sharpen or grind the mounting surfaces of the

blades. this will cause the edge to roll and the blade will

be damaged, resulting in poor chipping performance.
regrind the angled edge of the chipping blades to 45

degrees (Figure 5.2).
the blades can be ground on a bench grinder or by

a professional.
Make sure some type of fixture is used to correctly hold

the blade at the proper angle.
Be careful when grinding so that the blade does not

become overheated and change color. this will remove

the heat-treated properties.
use short grinding times and cool with water or some

type of liquid coolant.
remove an equal amount off each blade to maintain

rotor balance.
Small imperfections such as nicks and burrs on the

flat side of the blade will not affect the chipping per-

formance of the machine.
For blades that have been repeatedly sharpened,

ensure that the sharpened surface extends past the

chipping slot opening. if it does not extend past the

opening, the blades should be replaced.

Figure 5.2 - Double Edged Blade

Model 74500

MOUNTING SURFACE

DO NOT GRIND

SHARPENED

SURFACE

SHARPENED

SURFACE

DO NOT GRIND

MOUNTING SURFACE

.25

45˚

MOUNTING SURFACE
DO NOT GRIND

MOUNTING SURFACE

DO NOT GRIND

SHARPENED
SURFACE

SHARPENED
SURFACE

45˚

.38

Model 74800

5.3 removing The blades

5.4 sharPening The blades

This manual is related to the following products: