beautypg.com

Warning – Echo 74500 Owners Manual v.4 User Manual

Page 15

background image

5" and 8" Skid Steer Chipper Owner's Manual

13

OPERATION

Wear appropriate eye, face, and hearing protection.

Wear gloves that fit tight against the wrist.
remove the latch from the side of the feed table.
lower the chipper feed table.
Check that the feed roller is clear of material.
Place the feed roller control in the “stop” position.
Push down the latch and rotate the discharge chute to

the desired position.
release the handle and move the chute until it locks

the chute in position.

running the skid steer chipper is a one- or two-man

operation. if the system mandates an operator in the

driveseat, two people are needed. the chipper engages

with the hydraulics of the skid steer, as do most skid steer

powered attachments.

Set parking brake.
ensure the feed roller is in the neutral position.
engage the hydraulics of the skid steer to supply power

to the unit. the chipper will start to spin.
Place the feed roller in the operating position and bring

the unit up to speed.
the chipper is ready to chip.

1.

2.
3.
4.
5.
6.

7.

1.
2.
3.

4.

5.

the operator should disengage the feed roller after all

material has been cleared from the chipper.
the operator should then slow down the engine of the

skid steer to idle and after several seconds disengage

the skid steer hydraulics.

the feed roller control has four positions:

reverse: reverses the direction of the feed

roller. use this function to clear a plugged

feed roller.
stop: Stops the feed roller.
forward: Feeds material into the chipper.
reverse: reverses the direction of the feed

roller.

The feed roller speed is adjustable with a hand crank located

below the chipper feed table. use a slower feed roller speed

when feeding large branches into the chipper. increase the

feed roller speed when feeding small branches into the

chipper. turning the crank counterclockwise decreases the

feed roller speed. turning the crank clockwise increases

the feed roller speed.

1.

2.

a.

b.
c.
d.

Figure 4.6 - Feed Roller Speed Adjustment

Figure 4.5 - Anti-Luce Connector

4.6 sTarTing The chiPPer

4.5 Pre-oPeraTion

4.7 sToPPing The chiPPer

4.8 feed roller oPeraTion

do not attempt to bypass the safety systems of the skid

steer loader.

Warning

This manual is related to the following products: