Echo 74500 Owners Manual v.4 - Manual (Page 10)

5" and 8" Skid Steer Chipper Owner's Manual 8
ASSEMBLY
Figure 2.4 - Mounting the Chipper Chute Support.
2.2.2 mounTing The chuTe suPPorT:
Make sure the chute is mounted to the roller support
weldment.
Place the chute support underneath the chute.
the side of the chute support with the two mounting
holes is orientated towards the chipper base.
attach the chipper chute to the base with the provided
3/8” bolts, washers and nuts. it may help to slightly lift
the chipper chute.
align the other hole of the chipper chute support with
the hole in the chipper chute.
insert the other 3/8” bolt , washer, and nut. tighten to
proper torque.
1.
2.
3.
4.
5.
6.
Place the 4 position valve on the chipper chute over
the three pre-drilled mounting holes.
From the inside of the chipper chute, using the 5/16”
x 3/4” bolts, and washers, thread the bolts into the
four-position valve.
tighten 5/16” hardware to proper torque.
attach the valve control lever according to Figure 2.6.
tighten the 5/16” bolt to the proper torque.
1.
2.
3.
4.
5.
Figure 2.6
Figure 2.5 - Mounting the Four Position Valve.
2.3 mounTing The four-PosiTion valve
Connecting the Valve Control Lever to the 4 Position Valve.