Echo 73413 Owners Manual v.3 - Manual (Page 9)

4 INCH CHIPPER 5
ENGLISH
SAFETY
CHECk BlADE BOlTS FOR
PROPER TORQuE AFTER EVERy
8 HOuRS OF OPERATION.
CHECk BlADES AND ROTATE
OR RESHARPEN DAIly OR AS
REQuIRED TO kEEP BlADES
SHARP. REFER TO OWNERS
MANuAl FOR INSTRuCTIONS.
FAIluRE TO DO SO MAy CAuSE POOR PERFORMANCE,
DAMAgE OR PERSONAl INJuRy AND WIll VOID THE MACHINE
WaRRantY.
1.10 SaFETY dECaLS
pN 12169
2
pN 12172 3
pN 12173
4
pN 12174
5
pN 12175
6
pN 12183
7
pN 12168
1
pN 13711-00
9
pN 12250
8
See Section 1.9 for decal locations. Familiarize yourself with all of the safety and operating decals on the machine
and the associated hazards. See the engine owner’s manual or contact the engine manufacturer for engine safety
instructions and decals. Make certain that all safety and operational decals on this machine are kept clean and in good
condition. decals that need replacement must be applied to their original locations.
CONTACT WITH ROTATINg
DRIVElINE CAN CAuSE
DEATH. DO NOT OPERATE
WITHOuT All DRIVElINE,
TRACTOR AND EQuIPMENT
SHIElDS IN PlACE. ENSuRE
THE DRIVElINE IS SECuREly
ATTACHED AT BOTH ENDS AND DRIVElINE SHIElDS THAT TuRN
FREEly ON THE DRIVElINE ARE IN PlACE.
kEEP HANDS AND FEET OuT OF INlET AND
DISCHARgE OPENINgS WHIlE MACHINE
IS OPERATINg TO AVOID SERIOuS
PERSONAl INJuRy. STOP AND AllOW
MACHINE TO COME TO A COMPlETE STOP
BEFORE ClEARINg OBSTRuCTIONS.
READ AND uNDERSTAND THIS
OWNER/OPERATORS MANuAl.
BE COMPlETEly FAMIlIAR WITH
THE CONTROlS AND THE PROPER
uSE OF THIS EQuIPMENT
OBTAIN AND WEAR SAFETy
glASSES AND uSE HEARINg
PROTECTION AT All TIMES WHEN
OPERATINg THIS MACHINE.
BEFORE INSPECTINg OR
SERVICINg ANy PART OF THIS
MACHINE, SHuT OFF POWER
SOuRCE, REMOVE THE kEy,
DISCONNECT SPARk Plug WIRE
FROM SPARk Plug AND MAkE
SuRE All MOVINg PARTS HAVE
COME TO A COMPlETE STOP.
DO NOT OPERATE THIS
EQuIPMENT IN THE VICINITy OF
BySTANDERS. DO NOT AllOW
CHIlDREN TO OPERATE THIS
EQuIPMENT. AlWAyS STAND
ClEAR OF DISCHARgE AREA
WHEN OPERATINg THIS MACHINE.
kEEP FACE AND BODy AWAy
FROM DISCHARgE AREAS.
DO NOT OPERATE MACHINE
WITHOuT SHIElDS IN PlACE.
FAIluRE TO DO SO MAy CAuSE
SERIOuS INJuRy OR DEATH.
kEEP HANDS AND FEET OuT
OF INlET AND DISCHARgE
OPENINgS WHIlE MACHINE IS
OPERATINg TO AVOID SERIOuS
PERSONAl INJuRy. STOP AND
AllOW MACHINE TO COME TO
A COMPlETE STOP BEFORE
ClEARINg OBSTRuCTIONS.
PRESS CluTCH PEDAl DOWN
WITH FOOT TO DISENgAgE
BElT WHIlE STARTINg
ENgINE. SlOWly RElEASE
FOOT TO ENgAgE CHIPPER
BElT AFTER CHIPPER IS
RuNNINg.
READ AND uNDERSTAND
THIS OWNER/OPERATORS
MANuAl. BE COMPlETEly
FAMIlIAR WITH THE CON-
TROlS AND THE PROPER
uSE OF THIS EQuIPMENT.