Echo 73413 Owners Manual v.3 - Manual (Page 14)

4 INCH CHIPPER 10
3.1.1 CHIppER CoNTRoLS
1. Trailer hitch: Always use 2 inch (50 mm) ball and
safety chains.
2. Jack stand: Always have in uP position and clear from
ground when moving. When in use, place in DOWN
position on a level surface.
3. belt guard: never remove guards when in use.
4. discharge tube: Chipped materials exit through the
rotatable discharge chute.
5. Chipper chute: Feed materials to be chipped through
the chipper chute.
6. Rotor shaft bearing cover: Covers rotor shaft and
front bearing.
7. belt engagement pedal: When the pedal is depressed,
the drive belt is disengaged. When the pedal is
released, the drive belt is engaged. Depress pedal to
start engine.
3.1 ENGINE modEL CoNTRoLS
Section
FEaTuRES & CoNTRoLS
3
1
2
3
4
5
6
7
3.1.2 HoNda ENGINE CoNTRoLS
1. Engine throttle: Changes engine speed. turn
knob clockwise for full throttle operation. Turn knob
counterclockwise for engine idle. Turn knob fully
counterclockwise to shut engine off. Refer to engine
manual for further engine operating instructions.
2. Engine choke: use when starting a cold engine. Pull to
on position when starting. push lever to oFF position
when engine is running.
3. key switch: turn to start engine. do not crank starter
for more than ten seconds or damage could result.
4. Fuel tank: Remove cap to fill.