Echo CH611DH Owners Manual v.5 - Manual (Page 28)

24 6 INCH CHIPPER
Section
TrouBleshooTinG
6
6.1 Flash coDe GuiDe For The conTroller
GuiDe To The conTroller Flash coDes
siGnal FreQuencY cause acTion To TaKe
Green
gREEN SOlID
Chipper has reached default chipping
RPM and forward feed is available.
Machine available for standard use.
gREEN
½ second on,
½ second off
Chipper has not reached chipping
RPM upon initial startup.
Slowly increase RPM.
gREEN
½ second on,
½ second off
Chipper RPM dropped while chipping.
Feed roller will automatically
reverse to bring RPM back up.
reD
RED
½ second on,
½ second off
Feed bar not in NEuTRAl upon initial
startup.
Place feed bar in NEuTRAl.
RED SOlID
Safety bar was activated and
forward coil or reverse coil faults
are not active.
Push Safety Bar Reset/Override
Switch.
RED FlASHINg
Machine has been below operational
RPM for more than 10 minutes.
10 minute timer is a safety feature
and will require the safety bar to
be returned to NEuTRAl position
before operation can resume.
amBer
AMBER
2 seconds on,
2 seconds off
Blade service code is active, feed bar
was placed in NEuTRAl after power
up and the control system has not
detected chipper RPM.
Service blades. Reset code by
turning key on and shift the feed
bar from REVERSE to REVERSE
then back 3 times. this must be
done within 60 seconds of turning
key on and the engine cannot be
running.
AMBER
Solid for 7 seconds,
then a long pause, then
repeat
Forward infeed coil fault. If active all
other codes are ignored.
Test wiring to forward coil. Replace
coil if out of specification.
AMBER
½ second on,
½ second off
Reverse coil fault. If active all other
codes are ignored.
test wiring to reverse
coil. Replace coil if out of
specification.