Echo CH611DH Owners Manual v.5 - Manual (Page 10)

6 6 INCH CHIPPER
Section
4
1
2
3
4
5
6
2
assemBlY
2.1 aTTach chipper chuTe - non ce complianT moDels
2
uSE OF A CERTIFIED HOIST OR OTHER lIFTINg
DEVICE WIll BE NEEDED TO PROPERly AlIgN
AND ATTACH CHIPPER CHuTE TO MACHINE.
noTice
Figure 2.1, CH611DH Feed Chute Attachment - Non-CE Compliant
non-ce complianT moDels (wiThouT saFe-
TY Bar)
1. Attach the feed chute (1) to the chipper body using eight
3/8 x 1-1/4" carriage bolts (2) and two 3/8 x 1" carriage
bolts (4) washers and nylock nuts. For the two upper
and two lower bolt locations, insert the bolts from inside
feed roller housing. The other six bolts mount on the
outer flanges of the feed roller housing and feed chute.
There is a coated clamp (3) bolted to the chipper body in
the lower left mounting hole. It is necessary to remove this
clamp and bolt and re-bolt it to the feed chute in the same
position. Do not tighten completely at this time.
2. Bolt the chute support (5) to the chipper frame with two
3/8 X 1" carriage bolts (4), one 3/8 x 1-1/4" carriage
bolt (2), washers and nylock nuts.
3. Bolt the chute support (5) to the feed chute hinge by
removing the existing 3/8 X 1-1/4" hex bolt (6), washer
and nut and replace in the same location securing the
cute support.
4. now go back and tighten the bolts and nuts
attaching the feed chute to the housing.
5. Connect the wires coming from the feed chute to the
connectors that are located underneath the chipper feed
roller. The color of the cable ties on the chipper wires
indicate which wire they should be connected to.