Echo CH611DH Owners Manual v.5 - Manual (Page 11)

7 6 INCH CHIPPER
ENGLISH
ASSEMBLY
4
1
2
2
3
8
4
5
6
7
9
10
2.2 aTTach chipper chuTe - ce complianT moDels
Figure 2.2, Control Box connection
Figure 2.3, CH611DH Feed Chute Attachment - CE Compliant models
ce complianT (wiTh saFeTY Bar)
1. Attach the feed chute(1) to the chipper body using eight
3/8 x 1-1/4" carriage bolts(2) and two 3/8 x 1" carriage
bolts(4) washers and nylock nuts. For the two upper
and two lower bolt locations, insert the bolts from inside
feed roller housing. The other six bolts mount on the
outer flanges of the feed roller housing and feed chute.
There is a coated clamp(3) bolted to the chipper body in
the lower left mounting hole. It is necessary to remove this
clamp and bolt and re-bolt it to the feed chute in the same
position. Do not tighten completely at this time.
2. There is also a coated clamp(7) bolted to the bottom of the
feed chute at the hinge point. It is necessary to remove
the 3/8 x 1-1/4" hex bolt(6) and clamp to route the wire
harness through the clamp. noTe: this same bolt will
be used to attach the chute support(5) to the feed chute
in step 4.
3. Bolt the chute support(5) to the chipper frame with two
3/8 X 1" carriage bolts(4), one 3/8 x 1-1/4" carriage
bolt(2). washers and nylock nuts.
4. Bolt the chute support to the feed chute at the hinge
location using the 3/8 X 1-1/4" hex bolt, coated clamp
(with harness routed through it), washer and nut
removed in step 2.
5. Bolt the license plate bracket(8) to the chute support
using two 5/16 x 1" carriage bolts(9), and to the feed
chute with two 5/16 x 3/4" carriage bolts(10) with proper
washers and nuts for all four.
6. now go back and tighten the bolts and nuts
attaching the feed chute to the housing.
7. Connect the wires coming from the feed chute to the
connectors that are located underneath the chipper feed
roller. The color of the cable ties on the chipper wires
indicate which wire they should be connected to.