Echo 72620 - Manual (Page 10)

6 INCH CHIPPER 6
section
2.2 aTTach chiPPer chuTe
Mount the chipper chute to the frame mounting bracket 1.
using eight carriage bolts and locknuts (see figures
2.1 or 2.2). Use three bolts on each side and two on
the bottom.
Tighten bolts to 35 ft-lbs.
2.
1-1/2” CARRIAGE BOLT
3/8” WASHER
3/8” NYLOCK NUT
Fig. 2.1, Attaching the chipper chute for the gravity feed model
assemblY
2.1 Trailer Wheels and hiTch
Remove the chipper from its shipping crate. Place the 1.
unit on a level surface before assembling.
Support the frame on wood blocks or other support
2.
device.
Mount the two tires and rims to the axle assembly with
3.
the supplied lug nuts.
Mount the trailer hitch assembly to the frame using
4.
three 3/8" x 3-1/2" bolts and locknuts.
noTe
See the torque chart in the back of the manual for proper
tightening of bolts.
do not operate this unit without the chipper chute
correctly installed. Rotating cutting blades can cause
serious personal injury.
Warning
2
2.3 connecT The conTrol cable
INSERT CABLE
THROUGH HOLE
NUT
CLEVIS
ASSEMBLY
DETENT
BALL
FEED
CONTROL
LEVER
CABLE
ANCHOR
WELDMENT
HYDROSTAT
CONTROL
CABLE
Remove the clevis assembly from the hydrostatic 1.
control cable end (see Fig. 2.4). Remove one nut on
the cable end. Insert the cable end into the hole in
the cable anchor weldment. Replace the nut and the
clevis assembly.
Attach the clevis assembly to the center hole on the
2.
feed control lever.
Adjust the cable detent ball to hold the control arm in
3.
the forward position or neutral position detents.
Fig. 2.3, Control Cable Assembly
1-1/2” CARRIAGE
BOLT
3/8” NYLOCK
NUT
model ch6614
model ch6614h
Fig. 2.2, Attaching the chipper chute for the hydraulic feed model