Fe2_vp6_undershoot_pct, Fe2_vp6_temporal_resampling, Fe2_vp6_temporal_down_watermark – Google Flix Engine Linux Reference Manual User Manual
Page 57
5.14 VP6
51
5.14.4.18
#define FE2_VP6_STREAM_PREBUFFER
Seconds of preload that are necessary before starting playback.
The buffer is used to maintain a consistent datarate and minimize playback interruption.
Note:
Default: 6
Attention:
Valid for CBR only
Definition at line 301 of file vp6.h.
5.14.4.19
#define FE2_VP6_TEMPORAL_DOWN_WATERMARK
Codec parameter for temporal down watermark percentage.
Specifies the percentage of the datarate buffer remaining below which the encoder is allowed to start drop-
ping frames. Only used if
is enabled.
Note:
Default: 20
A larger percentage will make it more likely frames will be dropped to achieve the requested
. The converse is also true.
Definition at line 281 of file vp6.h.
5.14.4.20
#define FE2_VP6_TEMPORAL_RESAMPLING
Codec parameter for temporal resampling.
In particularly difficult regions, if enabled, the encoder will drop frames to achieve the target the data rate.
The value of
FE2_VP6_TEMPORAL_DOWN_WATERMARK
determines the percentage of the datarate
buffer below which the encoder is enabled to start dropping frames.
Note:
Default:
Attention:
Setting
to
or
will unconditionally
set this value to 1. In this case adjusting
FE2_VP6_TEMPORAL_DOWN_WATERMARK
may im-
prove results.
Definition at line 271 of file vp6.h.
5.14.4.21
#define FE2_VP6_UNDERSHOOT_PCT
Codec parameter for undershoot percentage.
This value is given as a percentage. Creates output that targets a slightly lower datarate so there are bits
available in the buffer to improve difficult sections.
Generated on Tue Jul 20 17:39:03 2010 for Flix Engine Linux by Doxygen