JLG R6 - Manual (Page 31)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION AND INSPECTION
3121684 – JLG Lift – 2-9
drive with the platform above elevation unless
the pot-hole-protection system is fully lowered.
e. With the platform elevated on a smooth, firm,
level surface with no overhead obstructions, drive
the machine to check if the high drive cutout
speed-limit is engaged at the height indicated in
Table 2-2. Ensure drive speed is reduced from a
higher speed to a slower speed. Limit switch loca-
tions shown in Figure 2-2. on page 2-10.
f. Ensure that all machine functions are disabled
when the platform Emergency Stop Button is
depressed.
3. With the platform in the transport (stowed) position.
a. Drive the machine on a grade, not to exceed the
rated gradeability, and stop to ensure the drive
motor brakes hold.
b. Check the tilt indicator light to ensure proper
operation. The light should be illuminated if tilted
beyond allowed settings in Table 2-3.
NOTE: When the tilt indicator warning is activated the following
functions are affected;
Platform Lowered: Only Drive Allowed.
Platform Raised: Drive and lift up functions are disabled,
platform must be fully lowered (stowed) to drive out of tilt
condition.
Table 2-2. High Drive Speed Cutout Height
MODEL
HIGH DRIVE SPEED
CUTOUT HEIGHT
DRIVE SPEED REDUCTION
R6 1.5m (59 in.)
4.0 kph (2.5 mph) to
0.8 kph (0.5 mph)
Table 2-3. Tilt Activation Setting - Australia
MODEL
TILT SETTING
(front to back)
TILT SETTING
(side to side)
Maximum Deck Elevation
R6 3°
1.5° 5.64 m (Full) 18.5 ft.
2° 5.2 m 17 ft.
3° 4.6 m 15 ft.