JLG 4017RS Operator Manual - Manual (Page 74)

Section 4 - Operation
4-10 31200938
4.4 ROAD OPERATION (CE)
1. Preparation
a. Remove load from attachment.
b. Remove any large amounts of dirt from machine.
c. Check lights and mirrors and adjust if necessary. Rear lights must be orientated in
the horizontal position.
Note: Be sure to follow all local and federal/provincial traffic regulations.
2. Lower boom. Lowest part of attachment should be approximately 30 cm (12 in)
above the ground.
3. Fully tilt attachment back.
4. Place protective shield over front bucket edge: remove or reposition carriage forks
toward the machine and secure to the carriage.
5. Depress button (1) to deactivate joystick function and disable all joystick controlled
functions.
6. Changes steer mode to front wheel steering (2). See “Steer Modes” on page 3-24 for
details.
7. Machine is now ready for road operation.
OZ4190
2
1