Section 5 - attachments, 1 approved attachments, 2 unapproved attachments – JLG 4017RS Operator Manual User Manual
Page 81: Approved attachments -1, Unapproved attachments -1, Tion 5 - attachments, Warning
Section 5 - Attachments
5-1
31200938
SECTION 5 - ATTACHMENTS
5.1
APPROVED ATTACHMENTS
To determine if an attachment is approved for use on the specific telehandler you are
using, perform the following prior to installation.
• The attachment type, weight, dimensions and load center must be equal to or less
than the data shown on a capacity chart located in the operator cab.
• The model on the capacity chart must match the model telehandler being used.
• Hydraulically powered attachments must only be used on machines equipped with
auxiliary hydraulics.
If any of the above conditions are not met, do not use the attachment. The telehandler
may not be equipped with the proper capacity chart or the attachment may not be
approved for the model telehandler being used. Contact JLG or the local dealer for further
information.
5.2
UNAPPROVED ATTACHMENTS
Do not use unapproved attachments for the following reasons:
• Range and capacity limitations for “will fit,” homemade, altered, or other
non-approved attachments cannot be established.
• An overextended or overloaded telehandler can tip over with little or no warning and
cause serious injury or death to the operator and/or those working nearby.
• The ability of a non-approved attachment to perform its intended function safely
cannot be assured.
WARNING
Use only approved attachments. Attachments which have not been approved for use
with your telehandler could cause machine damage or an accident.