JLG T500J Operator Manual - Manual (Page 15)

SECTION 1 - SAFETY
3121197 – JLG Lift – 1-3
• Do not operate this machine until it has been serviced and
maintained according to requirements specified in the Service
and Maintenance Manual.
• Be sure the enable trigger and all other safety devices are
operating properly. Modification of these devices is a safety
violation.
MODIFICATION OR ALTERATION OF AN AERIAL WORK PLATFORM SHALL BE MADE
ONLY WITH WRITTEN PERMISSION FROM THE MANUFACTURER
• Do not operate any machine on which safety or instruction
placards or decals are missing or illegible.
• Check the machine for modifications to original components.
Ensure that any modifications have been approved by JLG.
• Avoid any buildup of debris on the platform floor. Keep mud,
oil, grease, and other slippery substances from footwear and
platform floor.
1.4 OPERATION
General
• Do not use the machine for any purpose other than position-
ing personnel, their tools, and equipment unless using the
optional JLG Material Hook attachment.
• Never operate a machine that is not working properly. If a mal-
functions occurs, shut down the machine.
• Never slam a control switch or lever through neutral to an
opposite direction. Always return switch to neutral and stop
before moving the switch to the next function. Operate con-
trols with slow and even pressure.
• Hydraulic cylinders should never be left fully extended for
long periods of time.
• Do not allow personnel to tamper with or operate the
machine from the ground with personnel in the platform,
except in an emergency.
• Do not carry materials directly on platform railing unless
approved by JLG.
• When two or more persons are in the platform, the operator
shall be responsible for all machine operations.